This DiSEqC 4 x 1 switch can help you receive digital and analog satellite from 2 universal LNBs. As usual, the polarization and bands are switched by 14V / 18V and 22 KHz. Then the Satellite A / Satellite B (SA/SB) DiSEqC command is used to select one signal. It also supports mini DiSEqC commands so you can use " SimpleTone Burst" to control it without a full DiSEqC receiver.


NOTE:
•This device supports up to DiSEqC v2.0 which means that any DiSEqC receiver of earlier DiSEqC versions will also operate correctly with this device.
•DiSEqC = Digital Satellite Equipment Control.
•'DiSEqC' is a trademark of EUTELSAT.
•EUTELSAT = European Telecommunications Satellite Organization.

DS-41W
•DiSEqC 2.0 supports bi-directional DiSEqC full control function
•Allow remote units to report their possible and actual configuration
•Backwards compatibility with Tone Burst
•Outdoor and indoor usage
•Sheet metal housing and weather-cap

DS-41S
•DiSEqC 2.0 supports bi-directional DiSEqC control function
•Allow remote units to report their possible and actual configuration
•Super compact housing design
•Zinc die cast housing

DSW-41
•Built-in switch for control mode
•DiSEqC 1.0 or tone burst or 22kHz tone
•Suitable for various existing satellite receivers

Specification		DS-41W	DS-41S	DSW-41
Input Frequency	(MHz)	950~2300MHz	950~2300MHz	47~2300MHz
Insertion Loss	(dB)	2	2	4
Return Loss	(dB)	8	8	8
Isolation	(dB)	20	20	25
Current Consumption	(mA)	10	20	40
Max. Current To LNB	(mA)	500	500	500
In/Out Connector		75Ω F-(f)	75Ω F-(f)	75Ω F-(f)
Dimensions	(mm)	97x101x23	65x41x14	86x93x25
With Weather-Cap		O	X	X
Selection Table	SAT
LNB A → RX	A	A	A	A
LNB B → RX	B	A	A	A
LNB C → RX	A	B	B	B
LNB D → RX	B	B	B	B

Brochure